Water Eject
for Phone Speakers
Got water in your speaker? Our free water eject tool uses a precise 165Hz sound wave to vibrate moisture out of your phone’s speaker grille in under 2 minutes — no app, no download.
your speaker now
What is water eject?
The free way to fix a wet speaker — no rice, no repair shop
Water eject is the technique of playing a specific low-frequency tone through a speaker to physically vibrate water droplets out of the grille mesh.
When your phone falls in water, gets caught in rain, or sweats in your pocket, water droplets become trapped inside the fine mesh of your speaker grille. This causes muffled, distorted, or completely silent audio — even after the phone itself appears dry.
The 165Hz frequency is uniquely effective because it matches the resonant frequency of the water-and-mesh system. When the speaker cone vibrates at this frequency, it creates micro-pressure pulses that force trapped water outward through the grille rather than deeper into the device.
This is the same principle behind Apple Watch’s Water Lock feature, which ejects water after swimming using a 167Hz tone — just two Hz apart from our tool. The technique is proven, safe, and requires no physical contact with the device internals.
Resonance physics
At 165Hz, the speaker membrane oscillates at precisely the frequency needed to overcome water’s surface tension inside the mesh.
Instant action
Unlike the rice method (which takes 24–48 hours with questionable results), sound-wave ejection works in real time — you hear improvement during the first play.
Zero risk
165Hz is a completely normal audio frequency used in music daily. It cannot damage speaker hardware and is safe for all phone models.
How to use
5 steps to eject water from your phone speaker
Disconnect all audio output
Remove any wired headphones and disconnect Bluetooth devices. The tone must play through your phone’s built-in speaker — not through earbuds or external speakers.
💡 Check your notification bar for active Bluetooth connectionsSet volume to maximum
Use your phone’s volume buttons to turn the ringer/media volume all the way up. Maximum volume = maximum vibration amplitude = best water ejection.
💡 On iPhone: also check that silent mode (side switch) is offTilt phone speaker-side down
Hold your phone horizontally with the speaker grille facing downward. Gravity assists the ejected water droplets in falling away from the device rather than back into it.
💡 For bottom-firing speakers: hold the phone landscape with bottom edge downPress Eject Water — let it finish
Tap the blue button above and keep the phone steady until the 4-minute tone completes. You should see a visible progress bar. Do not interrupt the playback mid-cycle.
💡 You may see tiny water droplets appear on the speaker grille — this means it’s workingRepeat and air-dry
Play the water eject tone 2–3 times for best results. Then leave your phone upright in a dry, ventilated space for 30 minutes. Avoid charging until fully dry.
💡 Still muffled after 3 rounds? Try the 8-minute deep-clean mode on our home pageDevice compatibility
Works on every phone and earphone
Any device with a speaker and a web browser can use this tool.
Do you need water eject?
6 signs your speaker has water in it
Muffled or quiet audio
Sound that was clear before suddenly sounds like it’s coming through a pillow — classic water-in-grille symptom.
Crackling or distortion
Water on the speaker membrane causes rattling distortion especially at higher volumes.
Recently got wet
Phone got splashed, rained on, or briefly submerged — even IP67/IP68 phones can trap water in the grille.
Only one side working
Stereo phones with top and bottom speakers — if one sounds fine and one is muffled, water is likely in the affected grille only.
Callers sound underwater
Call quality is affected but music seems OK — the earpiece speaker (top of phone) may have separate water ingress.
After heavy sweating or rain
Sweat is water too. Running or working out in humid conditions can push moisture into speaker grilles over time.
FAQ